Doing a lab task

Note that the time allowed for a lab completion might be limited. Find the information on your lab session duration in the course that you take.

To take a lab task in your course:

1. Log in to your account in the Learning Management System you use.
2. Navigate to the course and open the respective unit with the lab.
3. Click Start lab. Wait till the lab environment starts.
4. Carefully read the instructions and a task. For a coding task, enter your solution into the code editor pane on the right.

   Note: Make sure to check carefully the syntax and punctuation marks that you use in your response before submitting it.

5. Click Run to check if the solution is correct. The lab will check your input against pre-configured criteria and return the result at the button of the pane in the Status section.
6. If any adjustment is needed, read hints and check your answer. Correct the answer and click Run again.
7. When you complete all the lab tasks, click Submit and review.

To navigate between the lab tasks, use the Back and Next buttons.